MSI Wind Top AE2200 Manuel d'utilisateur télécharger pdf (Page 5)

MS-6637

Safety Instructions

1. Always read the safety instructions carefully.

2. Keep this user’s manual for future reference.

3. Keep this equipment away from humidity.

4. Lay this equipment on a at and steady surface before setting it up.

5. The ventilator on the enclosure is used for air convection and to prevent the

equipment from overheating. Do not cover the ventilator.

6. Check the AC input: 100-240V~, 50-60Hz, 4A.

7. Make sure that the power voltage is within its safety range and has been ad-

justed properly to the value of 100~240V before connecting the equipment

to the power inlet.

8. Place the power cord in a way that people are unlikely to step on it. Do not

place anything on the power cord.

9. Always unplug the power cord before inserting any add-on card or module.

10. All cautions and warnings on the equipment should be noted.

11. Never pour any liquid into the opening that could damage or cause electrical

shock.

12. If any of the following situations arises, get the equipment checked by ser-

vice personnel:

■ The power cord or plug is damaged.

■ Liquid has penetrated into the equipment.

■ The equipment has been exposed to moisture.

■ The equipment does not work well or you can not get it work according to

user’s manual.

■ The equipment has dropped and damaged.

■ The equipment has obvious sign of breakage.

13. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT UNCONDI-

TIONED, STORAGE TEMPERATURE ABOVE 40

C (102

F), IT MAY DAM-

AGE THE EQUIPMENT.

WARNING:

1. For every changes in power cord’s usage, please use an approved power

cord with condition greater or equal to H05VV-F, 3G, 0.75mm

2. Internal part is hazardous moving parts, please keep ngers and other body

parts away.

3. For pluggable equipment, the socket-outlet shall be installed near the equip

ment and shall be easily accessible.

4. Do not disable the protective earth pin from the plug, the equipment must be

connected to an earthed mains socket-outlet.

5. Adjustment of the volume control as well as the equalizer to other settings

than the center position may increase the ear-/ headphones output voltage

and therefore the sound pressure level.

CAUTION:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type recommended by the manufacturer.

1. The optical storage devices are classied as a Class 1 Laser prod-

ucts. Use of controls or adjustments or performance of procedures

other than those specied is prohibited.

2. Do not touch the lens inside the drive.

廢電池請回收

For better environmental protection, waste batteries should be collected

separately for recycling or special disposal.

FCC-B Radio Frequency Interference Statement

This equipment has been tested

and found to comply with the limits

for a Class B digital device, pursu-

ant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may

cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the measures listed below:

■ Reorient or relocate the receiving antenna.

■ Increase the separation between the equipment and receiver.

■ Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

■ Consult the dealer or an experienced radio/television technician for help.

Notice 1

The changes or modications not expressly approved by the party responsible for compli-

ance could void the user’s authority to operate the equipment.

Notice 2

Shielded interface cables and A.C. power cord, if any, must be used in order to comply

with the emission limits.

VOIR LA NOTICE D’INSTALLATION AVANT DE RACCORDER AU RESEAU.

This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-

ing two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Micro-Star International

MS-6637

1 2 3 4 5 6 7 8 9 10 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

MSI Wind Top AE2200 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Postes de travail tout-en-un MSI Wind Top AE2200