MSI Supero CSE-M35S Guide de l'utilisateur télécharger pdf (Page 235)

ManageEngine Firewall Analyzer :: User Guide

234

Zoho Corp.

set traffic enable<cr>

set web enable<cr>

set email enable<cr>

set attack enable<cr>

set im enable<cr>

set virus enable<cr>

end <cr>

Type "show log syslogd filter" to list all available traffic.

•

Stop and start the Firewall Analyzer application/service and check if you are able to

receive the Fortigate Firewall packets in Firewall Analyzer.

Configure/Enable SNMP Protocol for Fortigate Firewall device

Using CLI Console:

Ensure SNMP is enabled in Fortigate box by using the below command:

get system snmp sysinfo

If it is disabled, enable it by using the below commands:

config system snmp sysinfo

set status enable

end

To enable the SNMP Manager running in Firewall Analyzer to make queries to SNMP

Agent running in the firewall:

config system snmp

edit <SNMP Community ID>

config hosts

edit <SNMP Community ID>

set interface <Interface through which Firewall Analyzer is connected to Firewall>

set ip <Firewall Analyzer machine IP address>

end

To ensure the source interface that connects Firewall Analyzer to Firewall device allows

SNMP traffic, execute the below command:

get system interface <interface name>

To allow SNMP traffic through the source interface use the below command:

config system interface internal

set allowaccess <proto1 proto2 SNMP>

end

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 308 309

Pas de commentaire

MSI Supero CSE-M35S Guide de l'utilisateur Page 235